Cart is empty
Replacement Ford 4 Button Keyless Entry Remote Key Fob
This remote includes free programming instructions!
FCC ID: CWTWB1U311
Alternate FCC ID: CWTWB1U322, GQ43VT11T, CWTWB1U212
Ford PN: 8S4Z-15K601-AA, F8DB-15K601-BA, F87B-15K601-BA, 2S4T-15K601-AA
This replacement key fob fits the following vehicles
2005 - 2009 Crown Victoria
2001 - 2012 Escape
1998 - 2003 Escort
1998 - 2012 Expedition
1998 - 2012 Explorer
2001 - 2001 Explorer Sport Trac
2005 - 2007 Five Hundred
2000 - 2012 Focus
2006 - 2012 Fusion
1999 - 2012 Mustang
1998 - 2012 Taurus
2002 - 2005 Thunderbird
2003 - 2005 Aviator
2001 - 2012 Navigator
1998 - 2009 Town Car
1999 - 2002 Cougar
2006 - 2011 Grand Marquis
2005 - 2011 Mariner
2005 - 2007 Montego
1999 - 2005 Sable
FORD REMOTE – THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE
1.Close all doors, then open drivers door and press the Unlock button on driver’s door while it is open, insert key into ignition.
2.Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
3.Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4.Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4. for all other remotes.
5.Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.
If the above procedure does not program the remote, please try this procedure
1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 10 seconds, press any button on first keyless remote. The system will chime once to confirm programming.
4. Within 10 seconds, press any button on second keyless remote. System will chime once to confirm programming.
5. Turn ignition to RUN to exit programming mode.
No posts found